Rock cutting machine notes - Huaqiang Electronic Network

Single Chip Microcontroller STM32L151CCU6

Spot Remarks 2017+

Brand AVX TPSE226M035R0125 Low Impedance Tantalum Capacitor AVX 22

Electronic Scale Crystal Oscillator 3.2x2.5mm 3225 16M (16.000MHz) 12PF 10PPM 20PPM 30PPM

Rock Cutting Machine - Safety and Operation Guidelines

When using a rock cutting machine, it's essential to follow proper safety procedures to ensure both the equipment and operator remain protected. Here are some key precautions to keep in mind:

1. When the cutter reaches the end of its movement, make sure to disengage the blade from the workpiece first. Only after the blade is completely separated should you turn off the machine and pump, then open the sealing door to remove the workpiece safely.
2. Diamond tools are expensive and delicate. Avoid any sudden impacts when clamping the rock to prevent blade deformation, which could affect cutting accuracy and quality.
3. During normal operation, avoid making rapid adjustments to the feed rate. Sudden changes can cause damage to the blade and other internal components of the machine.
4. If the machine makes unusual noises during cutting, stop immediately and inspect the system for potential issues before resuming operations.
5. Always monitor the coolant flow. Insufficient cooling can lead to excessive wear on the blade, reducing its lifespan and performance.
6. Ensure that all connections are properly sealed to prevent leaks. Install leak protection systems where necessary to maintain a safe working environment.

By following these guidelines, operators can extend the life of their equipment, improve cutting efficiency, and reduce the risk of accidents or damage. Regular maintenance and careful handling are also recommended to keep the machine in optimal condition at all times.