The famous car designer Henrik Fisk has established a new electric car company, Fisker. Recently, he began to show some pictures of the company's first electric car. The electric car, called Fisker EMoTIon, is positioned as a “luxury†in the electric car industry, claiming to be the first electric car to last up to 400 miles (644 km). The Fisker EMoTIon electric car has a top speed of 259 km/h. Thanks to the new graphene battery technology, the single-charge battery life reaches an astonishing 644 km, and the Bitsla Model S has an additional 136 km. The car battery pack will be produced by Fisker Nanotech, and the compact electric power system layout of the car will further expand the interior space. The body material is made of carbon fiber and aluminum. The lightweight material will give the Fisker EMoTIon better sports performance while reducing the weight of the car. According to Fisker, the hardware of the Fisker EMoTIon electric car will also support full autopilot functionality, but it is not immediately available. It is reported that the autopilot technology of the Fisker EMotion electric vehicle will be submitted to a third-party company for design and development. Fisker EMotion will be produced in the United States and is expected to be officially launched in mid-2017.
HDMI, known as High Definition Multimedia Interface, is mainly used for transmitting HD audio and video signals.
There are three types of data transmitted by HDMI TMDS (plus Hsync and Vsync count as four) :
1.Preamble (control information) is mainly used to control the Data to be transmitted next, namely Data Island or Video Data
2.Data Island, all kinds of packet information, including audio packet, image packet, etc
3.Video Data, Video pixel Data. HDMI can transmit pixel Data in RGB and YUV formats
4. And Hsync and Vsync
HDMI Source device (HDMI HPD) will monitor the Hotplug port of the sink device. If the Hotplug is High, it will prove that the device can work, and then read DCC; if it is low, it will prove that the device is disconnected.
The HDMI Sink device should notify the source device that EDID has been changed by pulling the Hotplug down, and the source device will read the new EDID again after the Hotplug is pulled up, which should be more than 100ms.
HDMI provides that the EDID can be read by DCC when the 5V pin of HDMI is powered on, that is, the Hotplug needs to be high, and some Hotplug is directly connected to the 5V
TMDS Clock is the Pixel Clock, the Clock frequency used for a Pixel point. Through TMDS Clock CLK pins transmitted to the receiver, but the receiver is not clear for what TMDS Clock frequency of the sender sent, so you need to through the Phy (Phy is analog to digital conversion section, is different from the ADC, Phy is don't know the sampling frequency, the need to lock frequency and phase lock, detect the exact input frequency) to lock.
Pc Hdmi Input,Hdmi Input Adapter,Hdmi Input Splitter,Hdmi Port On Tv Tonya Display Limited , https://www.tydisplay.com
